Would you like to react to this message? Create an account in a few clicks or log in to continue.

Totall Cell Phone Solution Is Here

    Repair ALL SX1 here

    an sanji

    Posts : 73
    Points : 1095
    Reputation : 4
    Join date : 2010-06-22

     Repair ALL SX1 here  Empty Repair ALL SX1 here

    Post by an sanji Thu Jul 15, 2010 11:07 pm

    Hey everybody !

    Here`s my next guide about Siemens reviving, now about this crazzzyyy SX1 !!!

    REPAIR ALL software Bugs of SX1, not going in SWUP mode, blinking, not turning on, dead .. etc

    Tools needed:
    V-Klay v3.3,
    [You must be registered and logged in to see this link.]
    Joker v3.4.3,
    [You must be registered and logged in to see this link.]
    SYMBIAN FULL Flash file 32Mb (with loader for V-Klay),

    [You must be registered and logged in to see this link.]
    E-Gold FullFlash 8Mb[You must be registered and logged in to see this link.]

    Hardware: ANY S-Gold based x65/75 phone (with 32Mb flash chip)

    There are 2 types of SX1:

     Repair ALL SX1 here  SX1

    One has BIG FlashIC, second has SMALL as ANY S-Gold x65 phones with 32Mb !
    For example, let`s say, we have SX1 with BIG Flash IC and a working C65 phone;

    So what you have to do is to put a SMALL FlashIC in this C65, as SX1 has BIG one it will not fit in C65 board, so you`ll need a SMALL flashIC from any x65 S-Gold phone (C65, CX65, ..etc)

     Repair ALL SX1 here  X65

    So now we have to Write a SX1 Symbian FLASH part in it

    Copy provided loader x65pv.vkd into V-Klay`s loader folder(V_KLay\data\Loaders), And open up V-Klay !
    Choose options like this:

     Repair ALL SX1 here  V-klay_model

    boot.bin will go, and you`ll hear a BEEP sound, soft saying Pause.bin, now you have to DISCONNECT TestPoint from ground, Software will boot and start prepairing to READ BACKUP, so just cancel it, then it will START WRITING Fullflash ...

    In about a half an hour (depends what speed you are writting full with), it will say Flashing Completed Successfully !!!

    Now take out the FLASH IC from C65 and put it in SX1 OMAP board, (reball it and resolder as well )

    See the balls which you will IGNORE

     Repair ALL SX1 here  SX1_BIG_REPLACE_with_SMALL

    After you have Resoldered it well, replace these 2 resistors and short the rest two
    You can see well in this picture:

     Repair ALL SX1 here  Howto_fromBIG_toSMALL

    Symbian Flash is DONE !

    What about E-Gold part ?!

    Now open up Joker, and Fullflash the phone with 8Mb fullflash, make recalc all keys after flashing as usual !

    AND POWER UP SX1 !!!!

    Damn this crazzzyyyy SX1 is working now !!!

    web-site access:
    User: GEORGIA
    Pass: Tbilisi

    Password of protected files is: Tbilisi

    Very BIG thanks to my friend DJON (vladvil) for helping

      Current date/time is Tue Dec 05, 2023 8:34 pm